13.0 Installer's Keypad and Installer Mode
13.1 Installer's Keypad Connector
The Installer's Keypad must be set to Address 0 (set MODE to OFF) and the Installer Switch must be
closed in order to program the panel from the keypad.
IMPORTANT
Figure 44 shows you how to connect and disconnect an Installer's Keypad (D623 or D625 Text Command
Center) and enter the Installer's Mode. Refer to D6412/D4412 Program Entry Guide (P/N: 45351) for complete
information on programming the panel from a keypad.
Use wire assemblies supplied with keypad and panel to create a double ended 'installer' cable.
13.2 Entering the Installer Mode
Press the [Cmd] key when the Text Command Center display prompts you to press the [#] key.
IMPORTANT
13.2.1 Installer's Passcode
To enter the Installer's Mode, first enter the installer's passcode and then press [Cmd] + [4] + [1]. The default
Installer Passcode is 6543210. The passcode length can be between 3 and 7 digits in length (default length is 4
digits, which shortens the default Installer passcode to 6543). To change the default passcode length, see
Section 2.9, Passcode Configuration, Installer Passcode, in the D6412/D4412 Program Entry Guide (P/N:
45351).
The system displays the installer's menu described in Section 13.3, Installer's Menu.
The Installer Switch must be closed to select Keypad Program from the Installer's Menu (see Figure 44).
IMPORTANT
© 2002 Radionics
R
Y
G
B
Back of Command Center
Figure 44: Installer's Keypad
D6412/D4412 Installation Guide
Connector supplied
with keypad.
Red
Yellow
Green
Black
Connector supplied
with panel.
Page 55
D6412/D4412
SDI Devices
R
Y
G
B
D6412/D4412 PCB
45349D