GPRS/GSM IP Communicator
3.3
Mount the ITS-DX4020-G in the Control Panel Enclosure
Refer to Figure 3.2, Page 13.
1.
2.
NOTICE!
The antenna must be placed on a magnetic metal surface for proper operation.
For best performance, ensure that the surface area extends 10 cm (4 in.) or more in all
directions around the antenna.
3.
Figure 3.2 Sample Mounting Location in Control Panel Enclosure
Callout
1
2
3
Bosch Security Systems, Inc.
Mount the ITS-DX4020-G into the control panel's enclosure using the supplied mounting
screws.
Use any of the standard three-hole mounting patterns on the control panel's enclosure. If
necessary, remove the three knockouts.If necessary, use the D137 Mounting Bracket (not
supplied) to mount the ITS-DX4020-G on the control panel enclosure.
Place the magnetic antenna in the vertical position on the top of the control panel
enclosure or other metal surface.
Connect the antenna cable to the ITS-DX4020-G.
Description
Sample mounting location and ITS-DX4020-G mounted at that location with
supplied mounting screws
Magnetic antenna (mount on top of the enclosure or other metallic surface);
route the antenna cable through the enclosure knockout
ANTENNA connector on ITS-DX4020-G
Installation and Operation Guide
Installation | en
13
F01U163066 | 01 | 2010.05