Operation; Filter Information - ElectrIQ eiQSRG60 User Manual

OPERATION

1. Press the "Power" button, to turn the cooker hood on and off.
2. Press the "Speed" button to cycle between fan speeds, the LED display will
indicate the fan speed with the numbers 1, 2 and 3.
3. Press "Lamp" button to turn the hoods light on and off.
4. Press the "Timer" button, and the cooker hood will start a countdown of 9
minutes (this will be shown on the display (9-8-7-6 etc.) When the timer has
finished, the cooker hood and all functions will be turned off. To cancel the
timer, press the timer button again.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for
about 3 minutes in water with a mild detergent and then
brush it gently with a soft brush. Please do not apply too
much pressure so as to avoid any damage to it. (Leave to
dry naturally out of direct sun light)
Filters should be washed separately to crockery and
kitchen utensils. It is advisable not to use rinse aid. Following the picture beside to
dismantle the grease filter.
INSTALLING GREASE MESH FILTERS
• To install filters for the following four steps:
- Angle the filter into slots at the back of the hood.
- Push the button on handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
Replacement filters can be purchased from the supplier of your
cooker hood using the following code:
Grease filter - eiqgfrg x 1
10