Lift Planning - PROLEC Liftwatch Rail Operator's Manual

4. Lift planning

Liftwatch Rail can be used for basic lift planning. The operator can perform a 'dummy' lift to check the machines performance against the actual
requirements for the lift. This option is code protected, when the system is in lift planning mode there is no safety functionality.
Lift data
Min SWL The minimum SWL encountered
(duty in which it occurred).
Min rad The minimum radius achieved (duty
in which it occurred).
Max rad The maximum radius achieved (duty
in which it occurred).
Min hgt Minimum bucket pin height encountered.
Max hgt Maximum height encountered.
Duties used List of duties the red trail passed through.
Liftwatch Rail Operators Manual 560386-000 Issue 1.2 © Prolec Ltd - Feb 2011
1.
Enter the correct code to access the
lift planning mode.

7
2.
Move the machine to the start position for the
planned lift. Press the 'dustbin' key to clear any
data that may already be displayed.
3
. With no load attached perform
the planned lift. A red trail will
appear on the screen plotting the l
lifting point's progress. Lift data
will be shown on the left of the
screen.
15 of 45