PROLEC Liftwatch Rail Operator's Manual page 33

Logger message
Aux slew input ON/OFF
25
Allow slew limiting ON/OFF
26
Allow height limiting ON/OFF
27
Mode Limit keyswitch ON/OFF
28
Customer X
29
Display relay action ON/OFF
30
Use SWL headroom ON/OFF
31
Cant sensor on chassis ON/OFF
32
A/B legacy mode ON/OFF
33
12 Volt machine ON/OFF
34
Road travel inhibit ON/OFF
35
Quick hitch fitted ON/OFF
36
Reeling drum fitted ON/OFF
37
Operator list ON/OFF
38
Limit override switch ON/OFF
39
Allow planning mode ON/OFF
40
Dual redundancy sensors ON/OFF
41
Edit basic machine data
42
Edit duty data for X
43
Log on opbypass
44
LOG ON Service
45
PTS expired X
46
Log on X
47
Bad PTS No
48
Liftwatch Rail Operators Manual 560386-000 Issue 1.2 © Prolec Ltd - Feb 2011
Secondary slew monitor enabled or disabled (default = ON)
Enable or disable slew limiting (default = ON)
Enable or disable height limiting (default = ON)
Enable or disable the mode limit and lift point key switch (default = ON)
Customer number (X = 1, 2, 3 or 4)
Enable or disable relay and opto input activity during normal operation (default = OFF)
Enable or disable the use of a minimum SWL ' headroom' calculation (default = ON)
Enable or disable dual-axis chassis sensor mounted on chassis (default = OFF)
Enable or disable support for early combi-box hardware (default = OFF)
Enable or disable use on 12 V machines (default = OFF)
Enable or disable travel inhibit monitoring (default = OFF)
Enable or disable quick hitch angle monitoring (option, default = OFF)
Enable or disable tele-arm extension monitoring (option, default = OFF)
Enable disable the use of Operator entry codes (default = ON)
Enable or disable the mode limit overrride key switch (default = ON)
Enable disable the use of Lift planning mode (default = ON)
Enable or disable the use of dual redundant sensors (default = ON)
The basic machine data has been changed
Individual duty data/calibration has been changed
Operator log on using the master code
Service log on using the service code
Attempt to log on with a name where the PTS code has expired
Successful operator log on
Attempted log on where the PTS code was invalid

16
Reason
33 of 45