PROLEC Liftwatch Rail Operator's Manual page 35

Logger message
I2C combi failure
73
Fuse X failure
74
Combi relay mismatch
75
Slew channel failure
76
Edit/view slew sectors
77
Access combi action
78
Test page accessed
79
Touchscreen re-calibrated
80
Lift point = Bucket pin
81
Lift point = Aux lift
82
Lift point = Grab
83
Soft limit override ON/OFF
84
Slew limiting ON/OFF
85
Height limiting ON/OFF
86
Backward Stability
87
Non RCI mode
88
RCI mode
89
Enter barred duty X
90
Auto axle lock ON
91
Maximum cant exceeded
92
Maximum gradient exceeded
93
Hyd.limit X
94
Oload X X X X X X
95
WARNING! X TOO HIGH
96
Liftwatch Rail Operators Manual 560386-000 Issue 1.2 © Prolec Ltd - Feb 2011
Combi-box internal communication bus has failed
A combi-box relay fuse has failed (X = 1 to 12)
One or more of the combi-box relays has failed to operate as instructed
Mismatch between the primary and secondary slew sensors
Attempt to edit or view the slew duty sector data
Attempt to view or adjust the combi-box configuration
Access to test page
The touch screen calibration was viewed or re-adjusted
The bucket pin was selected as the lifting point
The auxiliary lifting point was selected as the lifting point
The grab was selected as the lifting point
A change of state of the soft override function (not applicable to RIS1530 Issue 2)
Slew limitation was activated / deactivated
Height limitation was activated / deactivated
Backward stability alarm activated
Non-RCI mode selected
RCI mode selected
An attempt was made to enter a lifting duty that is barred for use
Auto-axle locking has been instigated (Colmar machines only)
The maximum allowable operational cant has been exceeded
The maximum allowable operational gradient has been exceeded
The maximum allowable hydraulic pressure has been exceeded
An Overload has occurred (X... = duty, %age overload, radius, height, and slew angle)
The height limit was exceeded (X = offending component, boom, artic, arm, bucket pin or quickhitch)

16
Reason
35 of 45