PROLEC Liftwatch Rail Operator's Manual page 34

Logger message
New op. file incompatible
49
New op. file too big
50
New operator file loaded
51
USB transfer launched
52
Master override ON/OFF
53
Travel mode de/selected
54
Offset boom not/straight
55
On road/rail
56
Axle un/locked
57
Network rail
58
London underground
59
Stabs UP/DOWN
60
Tele retracted/extended
61
C/wt not/retracted
62
Liebherr 'On Rail' Confirmation
63
Set sensor X offset
64
Set sensor X polarity
65
Edit sensor X offset
66
Set sensor X average
67
Calibrate slew sensor
68
Calibrate dual-axis sensor
69
Edit dual-axis sensor calib
70
Slew index failed HI
71
Relay power failed
72
Liftwatch Rail Operators Manual 560386-000 Issue 1.2 © Prolec Ltd - Feb 2011
Attempt to download an incompatible operator list file
Attempt to download an operator list file that is too big
Successful download of an operator list file
USB file transfer was requested
Combi-box override was instigated
Travel mode either selected or deselected
Offset boom either straight or not straight
Rail gear either deployed or not deployed
Oscillating axle either locked or unlocked
Network rail operation selected
LUL operation selected
Stabilisers either UP or DOWN
Tele-arm either IN or NOT IN (Colmar machines only)
Counter weight either IN or NOT IN (Colmar machines only)
Leibherr 'On Rail' operation and confirmed
Angle sensor offset set (X = Boom, Artic, Arm or Quick Hitch)
Angle sensor polarity set (X = Boom, Artic, Arm or Quick Hitch)
Angle sensor offset edited (X = Boom, Artic, Arm or Quick Hitch)
Angle sensor average set (X = Boom, Artic, Arm or Quick Hitch)
The slew sensor was calibrated
The dual-axis chassis sensor was calibrated
The dual-axis chassis sensor calibration was edited
The slew index switch has failed to operate (>370 degrees with no activity)
The independent power supply to the combi-box has been removed

16
Reason
34 of 45