Getting Started; Entry Code - PROLEC Liftwatch Rail Operator's Manual

1. Getting started

1.1 Entry code

Liftwatch Rail Operators Manual 560386-000 Issue 1.2 © Prolec Ltd - Feb 2011
Indicator LED's
Liftwatch Rail will
automatically turn on with
the ignition. The green
and amber LED's will flash
alternately as the system
starts. During this time the
screen will remain blank.
Touchscreen recalibration
button.
The system has been configured to work with the on-board Operator Database and
will prompt for a valid and in date operators pass code. Enter the correct operators
pass code using the on-screen key pad and press ENTER. If a valid PTS number is
entered the system will enter normal operation. If an incorrect entry is made, or the
pass code has expired, the failure reason will be displayed and a prompt to retry
offered.
The database can be edited, see section 15 for further details.
If problems with the touch screen are experienced, refer to the
calibration procedure outlined in section 15.
Liftwatch Rail is operated via the touch
screen soft keys that appear along the
base of the display. Once started, the
system will revert to the same state as
when it was last switched off.
Once the system has automatically
powered up, an introduction screen will
appear. Press the EXIT key to continue. If
no key is pressed, the system will
automatically start after a period of 5
seconds.
5 of 45