Assembly Instructions - Hotsy 555SS Operating Instructions And Parts Manual

assembly
unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling or operating pressure washer.
If there are missing components or hidden damage
immediately contact distributor or carrier concerning
discrepancies.
1. Cut strapping band from pressure washer and pallet.
2. Remove pressure washer from pallet.
parts included
• Pressure Washer
• Pressure Hose
• Wand Assembly
• Operating Instructions and Parts Manual
• Teflon Tape
tools required
• 10" Adjustable Crescent Wrench (2 ea.)
pressure hose
1. When assembling, use teflon tape on all plumbing
connections to prevent leakage.
2. Install high pressure hose on machine as shown in
figure 1.
Figure 1 - Pressure Hose Installation
6
assembly instructions
rupture
disk
pressure
hose
97-6230 • HOTSY 555SS • Rev. 12/06
3. Assemble pressure hose onto trigger gun/wand
assembly as shown in figure 2.
pressure hose
Figure 2 - Pressure Hose Installation
4. Make sure that all plumbing connections are tight.
trigger gun
Wand assembly