High
Pressure Hose
STEP 1: Attach the high pressure
hose to the spray gun.
Pressure
Nozzle
Wand
Collar
STEP 4: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Pump Water Inlet
STEP 7: Connect the garden hose
to pump inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.
8
ASSEMBLY INSTRUCTIONS
Spray
Gun
Safety
Latch
STEP 2: Attach wand to spray gun.
Tighten both by hand.
Wand
Coupler
STEP 5: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick. Use 40 wt.
non detergent oil.
Garden
Hose
ET • 8.922-845.0 • Rev. 03/14
Wand
Spray Gun
Dipstick
Wand
Coupler
Pressure
Nozzle
STEP 3: Pull the spring-loaded col-
lar of the wand coupler back to insert
your choice of pressure nozzle.
Coupler
Collar
STEP 6: Connect the high pressure
hose to the pump discharge fi tting.
Push coupler collar forward until
secure.
Pump
Discharge
Fitting
High
Pressure
Hose