Assembly Instructions - Hotsy ET-201006D Operator's Manual

Safety
Latch
High
Pressure Hose
STEP 1: Attach the high pressure
hose to the spray gun with quick
coupler.
Pressure
Nozzle
Wand
Coupler
Wand
Collar
STEP 4: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Garden
Hose
Pump Water Inlet
STEP 7: Connect the garden hose
to pump inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.
ZE/ZEF-ET-HD-HE • 8.914-001.0 • 8.941-457.0 • 9.800-088.0 • 8.919-017.0 • Rev. 11/15

ASSEMBLY INSTRUCTIONS

Spray
Gun
Nozzle
Extension
STEP 2: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 5: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick. Use 40 wt.
non detergent oil.
Pressure
Spray Gun/
Wand
STEP 3: Pull the spring-loaded col-
lar of the wand coupler back to insert
your choice of pressure nozzle.
Pump Discharge
Dipstick
High
Pressure
Hose
STEP 6: Connect the high pressure
hose to the pump discharge fi tting.
Push coupler collar forward until
secure.
Wand
Coupler
Nozzle
Fitting
Coupler
Collar
7