Advertisement

Read instructions carefully before attempting to assemble, install, operate or service this pressure washer.
Failure to comply with instructions could result in personal injury and/or property damage!
®
SERIAL NUMBER:
DATE PURCHASED:
FOR SALES AND SERVICE, PLEASE CONTACT:
NOTE: THIS MANUAL IS INTENDED FOR USE WITH
THE FOLLOWING MODEL RELEASE ONLY: 555SS

SPECIFICATIONS

Pump Volume At Pump Head: 2.2 GPM/132 GPH
Burner Type: Fuel Oil Fired, 214,300 BTU/Hr.
Burner Fuel Pressure: 150 PSI
Pump Pressure At Pump Head: 1300 PSI
Machine Voltage: 115 VAC/60 Hz/1 Ph
Total Machine Amperage: 20 Amps
Machine Weight: 280 Lbs.
Shipping Weight: 315 Lbs.
Exhaust Stack Size: 8"
Machine Dimensions: Length = 44", Width = 26", Height = 38"
MODEL 555SS

OPERATING INSTRUCTIONS

AND PARTS MANUAL
c
®
8.914-354.0

Advertisement

Table of Contents
loading

Summary of Contents for Hotsy 555SS

  • Page 1: Operating Instructions

    Read instructions carefully before attempting to assemble, install, operate or service this pressure washer. Failure to comply with instructions could result in personal injury and/or property damage! NOTE: THIS MANUAL IS INTENDED FOR USE WITH THE FOLLOWING MODEL RELEASE ONLY: 555SS SPECIFICATIONS ●...
  • Page 2: Introduction & Important Safety Information

    9. Never run pump dry or leave spray gun closed phase this product should only be connected to a longer than 1-2 minutes. power supply receptacle protected by a GFCI. 10. Keep operating area clear of all persons. 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 3 TRIGGER GUN KICKS BACK - HOLD WITH the infl uence of alcohol, prescription medications, 14. Be certain all quick coupler fi t- BOTH HANDS or drugs. tings are secured before using pressure washer. 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 4 IMPORTANT SAFETY INFORMATION Follow the maintenance instructions specifi ed in the manual. 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 5: Component Identification

    Detergent Valve — Allows you to siphon and mix Unloader Valve — Safety device which, when the detergents. spray gun closes, prevents over pressurization. Wand — Must be connected to the spray gun. 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 6: Assembly & Installation Instructions

    Adjust the air band for a #1 or #2 smoke spot on Figure 2 - Pressure Hose Installation the Bacharach scale. 4. Make sure that all plumbing connections are tight. 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 7: Operation

    The water faucet and supply hose trigger lock should be used whenever the trigger gun must be capable of providing 3.0 GPM. is not in use. 3. Fill fuel tank. Use kerosene, #1 grade home heating 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 8: General Cleaning Techniques

    See Figure 5. Turning the knob counterclockwise from dripping onto a rinsed area. For the best results, will pull detergent into the system. The fl ow may be contact your Hotsy dealer to help you select the best observed detergent for your application.
  • Page 9: Pump Motor

    • DO NOT allow pump to run dry. obstruction. • Winterize if storing in freezing temperatures, refer to Storage & Maintenance for details. • Use a water softener on the water system if known to be high in mineral content. 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 10: Troubleshooting

    . y l l l i f . s l . f f l l i g i l . y l y l l t e l 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 11 IMPORTANT If the pressure washer demonstrates other symptoms or the corrective actions listed do not correct the problem, contact the local authorized Hotsy Service Center. The Hotsy Service Center can be identifi ed by visiting www.hotsy.com 8.914-354.0 • HOTSY 555SS • Rev. 03/11...
  • Page 12 Hotsy does not authorize any other party, including authorized Hotsy Distributors, to make any representation or promise on behalf of Hotsy, or to modify the terms, conditions, or limitations in any way. It is the buyer’s responsibility to ensure that the installation and use of Hotsy products conforms to local codes.
  • Page 13 If you are looking for replacement parts for your Hotsy, please contact your local dealer. You can find a dealer by calling Hotsy at 800-525-1976 or by visiting www.hotsy.com.
  • Page 14 8.914-354.0 • Revised 03/11 • Printed in U.S.A. by Hotsy...

Table of Contents