Assembly Instructions - Hotsy 680SS Operating Instructions And Parts Manual

Unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling or operating pressure washer.
If there are missing components or hidden damage
immediately contact distributor or carrier concerning
discrepancies.
1. Cut strapping band from pressure washer and pallet.
2. Remove pressure washer from pallet.
Parts Included
• Pressure Washer
• Pressure Hose
• Hose Hanger
• Wand
• Wheels (4 Ea.)
• Axles (2 Ea.)
• Handle
• Parts Bag Containing:
■ Bolts 5/16" x 1-1/2" (5 Ea.)
■ Vinyl Cap
■ Nuts 5/16" (5 Ea.)
■ Washers 5/8" (10 Ea.)
■ Pressure Nozzle
■ Hubcaps (4 Ea.)
■ Spring Washers (4 Ea.)
■ Quick Disconnect
■ Quick Disconnect Plug
■ Trigger Gun
■ GFCI Cord Hanger
• Operating Instructions and Parts Manual
Tools Required
• 10" Adjustable Crescent Wrenches (2 Ea.)
• 11/16" Socket
• Hammer
• 7/16" Open End Wrench
• Teflon Tape
Pressure Hose and Wand
1. When assembling, use teflon tape on all plumbing
connections to prevent leakage.
2. Install pressure hose on machine as shown in
Figure 2.
Pressure
Hose
Figure 2 - Pressure Hose Installation
8

ASSEMBLY INSTRUCTIONS

Relief
Valve
HOTSY 680SS • 8.914-368.0
IMPORTANT: Before installing pressure hose onto the
trigger gun/wand assembly, turn on the water supply
and allow water to run from the end of the hose until
clear to prevent the nozzle from clogging.
3. Assemble wand components as shown in Figure 3.
Connect pressure hose to trigger gun.
4. Make sure that all plumbing connections are tight.
Quick Disconnect
Quick Disconnect
Plug
Trigger
Gun
Pressure Hose
Figure 3 - Wand Components
INSTALLATION
INSTRUCTIONS
Getting Started
IMPORTANT: Proper initial installation of equipment
will assure more satisfactory performance, longer
service life, and lower maintenance cost.
IMPORTANT: The use of a backflow preventer on
the water supply hose is recommended and may be
required by local code.
The pressure washer should be run on a level surface
and in a protected area where it is not readily influenced
by outside forces such as strong winds, freezing
temperatures, rain, etc. The pressure washer should
be located to assure easy access for filling of fluids,
adjustments and maintenance. Normal precautions should
be taken by the operator to prevent moisture from reaching
the pressure washer. It is recommended that a partition be
made between the wash area and the pressure washer
to prevent direct spray from the wand from coming in
contact with the pressure washer. Moisture reaching the
equipment will reduce the pressure washer's service life.
All installations must comply with the local codes covering
such installations.
Nozzle
Wand