Page 1
OPERATOR’S MANUAL ■ DB-2323 ■ DB-2324 ■ DB-2527 ■ DB-3030 ■ DB-3835 For technical assistance or the dealer nearest you consult our web page at www.hotsy.com 8.914-449.0...
The model and serial numbers will be found on a decal attached to the pressure washer. You should record both serial number and date of purchase and keep in a safe place for future reference. Hotsy DB • 8.914-449.0 • Rev. 07/11...
In an overfi lling situation, additional precautions are necessary to ensure that the situation is handled in a safe manner. WARNING: Risk of injury. Disconnect battery ground terminal before servicing. Hotsy DB • 8.914-449.0 • Rev. 07/11...
22. Never run pump dry or leave spray gun closed to operate the pressure washer. This machine longer than 1-2 minutes. must be attended during operation. Follow the maintenance instructions specifi ed in the manual. Hotsy DB • 8.914-449.0 • Rev. 07/11...
Detergent Injector — Allows you to siphon and mix water will discharge from pump protector onto detergents. fl oor. This system prevents internal pump dam- Wand — Must be connected to the spray gun. age. Hotsy DB • 8.914-449.0 • Rev. 07/11...
Water Inlet Garden Hose STEP 10: Check inlets fi lters, remove debris, then connect the garden hose to pump water inlet. CAUTION: Do not run the pump without water or pump damage will result. Hotsy DB • 8.914-449.0 • Rev. 07/11...
When the engine is not in use, leave the fuel valve in run position). Move the choke lever to the "Closed" the "OFF" position. position. To restart a warm engine, leave the choke lever in the "Open" position. Hotsy DB • 8.914-449.0 • Rev. 07/11...
Page 8
NOTE: For a more gentle rinse, select the white 40° or green 25° nozzle. To scour the surface, select the yellow 15° or red 0° nozzle. To apply de- tergent select the black nozzle. Hotsy DB • 8.914-449.0 • Rev. 07/11...
1-2 minutes . nozzle from the quick coupler. Select and install the desired high pressure nozzle. NOTE: You can also stop detergent from fl owing by simply removing detergent siphon tube from bottle. Hotsy DB • 8.914-449.0 • Rev. 07/11...
NOTE: Refer to the 3. Pour about one teaspoon of engine oil through engine manufacturer's manual for service and mainte- the spark plug hole, pull the starter grip several nance of the engine. Hotsy DB • 8.914-449.0 • Rev. 07/11...
Change oil. Direct spray away from machine. WATER High humidity in air Check and change oil twice as often. IN PUMP OIL (All models except Piston packing worn. Oil seal Call local distributor. 232336). worn. Hotsy DB • 8.914-449.0 • Rev. 07/11...
Page 12
Pump is sucking air Check that hoses and fi ttings are air tight. Turn off machine and purge pump by squeezing trigger gun until a steady fl ow of water emerges through nozzle. Hotsy DB • 8.914-449.0 • Rev. 07/11...
Check pump oil (all models except 232336) and engine oil level before fi rst use of your new pressure washer. Estimated Operating Estimated Operating Date Oil Changed Hours Since Last Date Oil Changed Hours Since Last Month/Day/Year Oil Change Month/Day/Year Oil Change Hotsy DB • 8.914-449.0 • Rev. 07/11...
Page 14
Hotsy does not authorize any other party, including authorized Hotsy Distributors, to make any representation or promise on behalf of Hotsy, or to modify the terms, conditions, or limitations in any way. It is the buyer’s responsibility to ensure that the installation and use of Hotsy products conforms to local codes.
Page 15
If you are looking for replacement parts for your Hotsy, please contact your local dealer. You can find a dealer by calling Hotsy at 800-525-1976 or by visiting www.hotsy.com.
Page 16
Form #8.914-449.0 • Revised 07/11 • Printed in U.S.A. or Mexico by Hotsy...