Table of Contents
Advertisement
Assembly Instructions
Unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling, or operating pressure washer.
If there are missing components or hidden damage,
immediately contact carrier concerning discrepancies.
Parts Included
•
Pressure Washer
•
Pressure Hose
•
Pressure Nozzles (3 Ea.)
•
Wand
•
Trigger Gun
•
Operations Manual
•
Gasoline Engine Manual
Pressure Hose, Trigger Gun and Wand
1. Install the pressure hose on the pressure washer
as shown.
Relief
Valve
NOTE: The pressure nozzle is not to be installed at
this time.
2. Assemble wand components as shown below.
3. Make sure all connections are secure.
Spray Gun
High Pressure Hose
Hotsy Gas Belt Drive Series Operator's Manual 8.931-236.0 - BD
Hose Quick
Disconnect
Outlet
Nipple
Manifold
Coil Outlet
Discharge
Wand
High
Pressure
Nozzle
Installation
Getting Started
IMPORTANT: Proper initial installation of
equipment will assure more satisfactory perfor-
mance, longer service life, and lower maintenance
cost.
IMPORTANT: The use of back-flow preventer on the
water supply hose is recommended and may be
required by local code.
The pressure washer should be run on a level surface
and in a protected area where it is not readily influ-
enced by outside forces such as strong winds, freezing
temperatures, rain, etc. The pressure washer should be
located to assure easy access for filling fluids, adjust-
ment and maintenance. Normal precautions should be
taken by the operator to prevent moisture from
reaching the pressure washer. It is recommended that
a partition be made between the wash area and the
pressure washer to prevent direct spray from the high-
pressure wand from coming in contact with the
pressure washer. Moisture reaching the pressure
washer will reduce its service life. All installations
should comply with the local codes covering such
installations.
IMPORTANT: DO NOT run machine indoors or in an
enclosed area where high ambient temperatures
exist. High ambient temperatures (above 100° F)
can cause engine oil failure and will greatly reduce
the engine's performance.
Venting
CAUTION: All venting must be in accordance with
applicable federal and state laws, and local ordi-
nances. Consult local heating contractors.
ATTENTION: Toute la ventilation doit être conforme
aux lois fédérales et de l'État ou de la province, et aux
réglementations locales applicables.
If the pressure washer is to be used in an enclosed
area, a flue must be installed to vent burner and engine
exhaust to the outside atmosphere. Be sure the flue is
the same size as the burner exhaust vent on the
pressure washer lid. Poor draft will cause the pressure
washer to soot and not operate properly. When
selecting the location for installation, beware of poorly
ventilated locations or areas where exhaust fans may
cause an insufficient supply of oxygen. Proper combus-
tion can only be obtained when there is a sufficient
supply of oxygen available for the amount of fuel being
burned.
Operations
11
Advertisement
Table of Contents
