First Use - U-Line UCDE215 User Manual & Service Manual

USER GUIDE

First Use

Initial startup requires no adjustments. If the unit was
turned off, press and hold
See "Control Operation" section for more details.
NOTICE
Temperature displayed reflects actual
temperature inside unit.
If the temperature displayed is different than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set points before
loading.
Setting CO2 Pressure
To minimize foam for most beverages the pressure should be set between 8-12 PSI.
• Set the pressure by turning the handle on the front of the regulator counterclockwise until it is all the way out. This will
turn the regulator off.
• Turn the valves on the bottom of the regulator to the side to ensure no CO2 will pass through the regulator.
• Pull the pin on the sides of the couplers to release built up pressure from the kegs. Open the faucets. Nothing should
come out initially as there is no pressure to the keg.
• Place a container under the faucets and open the valves on the bottom of the regulator.
• Turn the handle clockwise with the faucets open and your beverage will start to pour. Stop turning when you get the best
flow rate. This method should prevent your regulator from creeping.
If you are dispensing at altitude, you will need to increase your output pressure by one pound for every 2,000 feet of elevation
above sea level.
First Use
for 5 seconds to turn unit on.
Handle
Valves
21
u-line.com