U-Line UCDE215 User Manual & Service Manual page 12

USER GUIDE
Install Tower on Countertop
1. Use template to drill four mounting holes.
2. Drill 2-3/4" diameter hole through countertop.
3. Remove four Phillips screws (secured with nuts on the inside of the refrigerator) and lift off cap to reveal tower mounting
hole.
4. Slide keg refrigerator into place.
5. Position gasket over mounting hole.
6. Insert tubing into 2-3/4" hole.
7. Secure tower to countertop using four Phillips screws and nuts.
Note: Screws included with the kit will accommodate many different countertops. For a customized fit, it may be
necessary to acquire screws that are size to the thickness of your countertop.
8. Continue with CO2 and beverage connections.
NOTE: For proper operation of your refrigerator, IT IS NECESSARY to install air-tight insulation between the refrigerator and
the tower. The insulation will need to run from the interior of the refrigerator up into the interior of the tower.
Diagram A
2 ¾"
(70 mm)
Hole Diameter
General Installation
(see template at the end of this section)
Rear Wall
15"
(381 mm)
2"
Power Cord
(51 mm)
24 ¼"
7 ½"
(616 mm)
(19 1 mm)
12 ½"
(318 mm)
11 ⁄ "
(283 mm)
1 ⁄ "
(43 mm)
Front Face
of Unit
Insulation
Diagram B
Front edge of drilled hole
to front face of unit
11-1/8"
(283 mm)
Insulation
12
u-line.com
Countertop
Rear Wall
Beverage
Tube