Enable System Time To Synchronize With An Sntp Server - NETGEAR MS108EUP User Manual

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch
8. In the Address field, enter the address in the format compatible with Server Type.
9. In the Port field, enter the number of the port to use for UDP transmissions: 123, or
1025 to 36465.
For unicast transmissions between the SNTP client and an external SNTP server, this
port must be open in the firewall to allow access.
When the SNTP client mode is broadcast, only allow the internal SNTP server to
access the port.
10. In the Priority field, set a priority from 1 to 3, with the lowest number assigned to
the preferred SNTP server.
11. In the Version field, set the SNTP version from 1 to 4.
12. Click the APPLY button.
Your settings are saved.
The SNTP server information displays in a table.

Enable system time to synchronize with an SNTP server

The local system time on the switch can be set to sync with an SNTP server when the
following conditions are met:
• The SNTP client mode is configured.
• The switch can contact a configured SNTP server.
For more information, see Configure an SNTP server on page 87
To enable system time to synchronize with SNTP server time:
1. Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
4. In the SYSTEM TIME section, click the down arrow to expand the menu.
The system time options display.
5. Click the SNTP button to turn it green.
6. From the Time Zone menu, select the time zone in which the switch operates.
Maintain and Monitor the Switch 88 User Manual