Configure A Poe Schedule - NETGEAR MS108EUP User Manual

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch
• Temperature: The temperature in degrees Celcius.
• Fault Status: The error description when the PoE port is in a fault state:
No Error: The port is not in any error state and can provide power.
-
- MPS Absent: The port detected the absence of the main power supply,
preventing the port from providing power.
- Short: The port detected a short circuit condition, preventing the port from
providing power.
- Overload: The PD that is connected to the port attempts to draw more power
than allowed by the port's settings, preventing the port from providing power
at all.
- Power Denied: The port was denied power because of a shortage of power
or because of an administrative condition. In this condition, the port cannot
provide power.
- Startup Failure: The PD that is connected to the port failed to start up. In this
condition, the port does not provide power.
Over Voltage: The port was denied power because of a over-voltage lockout.
-
- Under Voltage: The port was denied power because of an under-voltage
lockout.
- Thermal Shutdown: The port detected a thermal temperature fault,
preventing the port from providing power.
• Output Power (W): The power that is delivered to the PD in watts.

Configure a PoE schedule

You can create a PoE schedule for a single port, or for multiple ports.
• PoE schedules are repeated weekly during the selected time range.
• On dates that are not included in a PoE schedule range, individual port settings
apply. For more information see Manage an individual PoE port on page 96.
To set up and enable a PoE schedule for one or multiple ports:
1. Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
Maintain and Monitor the Switch 99 User Manual