NETGEAR MS108EUP User Manual page 60

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch
• Select the ports on the switch that will participate in the LAG, as described in this
task.
• Enable the LAG on the switch and on the connected network device.
To set up a dynamic LAG on the switch:
1. Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
4. From the menu at the top of the page, select SWITCHING.
The QOS (quality of service) page displays.
5. From the menu on the left, select LAG.
The LAG page displays.
6. Click the tab for the LAG that you want to configure.
The text in the tab for the selected LAG displays green.
7. To add ports to the LAG, click the icons for the ports that you want to add (from 1
to 8).
The icon for a selected port displays purple.
A LAG must consist of at least two ports.
8. To enable a dynamic LAG, click the Static/LACP toggle.
When the LAG is set up as a dynamic LAG, the toggle button displays on the right
side of the toggle bar, and the bar displays green.
9. Click the APPLY button.
Your settings are saved.
Now that the LAG ports are selected, you must set up the physical link aggregation
connection. For more information, see Make a link aggregation connection on page
58.
Manage the Switch in Your
Network
60 User Manual