Manage Uninterrupted Poe - NETGEAR MS108EUP User Manual

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
4. Select POE > PD HEALTH MONITORING.
The PD Health Monitoring page displays.
5. Click the port where the PD that you want to test is connected.
When the port is selected, the port button displays solid purple.
6. Click the PD Health Monitoring button to enable the feature.
When enabled, the button bar displays green.
A status message displays to confirm whether the PD Health Monitor is ready.
The PD IP Address field displays the IP address of the PD.
7. In the Ping Time Interval field, enter the time interval in seconds for the ping test.
The default value is 60 seconds.
8. Click to enable or disable the If an error occurs while the PD Health Monitor is
running, restart the PoE toggle.
When enabled, the button displays on the right of the toggle, and the toggle bar
displays green.
9. Click to enable or disable the If the Restart Count is over 5 then disable PoE
option. If you want to use a different count value, select 10 or 20 from the menu.
The option is disabled by default, with the count set to 5.
10. When your settings are complete, click the APPLY button.
The ping test on the PD begins.
Total Count: The number of ping tests conducted.
Failure Count: The number of tests where the ping failed to complete.
Restart Count: The number of times that the PoE port was reset.

Manage uninterrupted PoE

If you enable the uninterrupted PoE feature, the switch continues to provide PoE power
to any attached PDs while the switch is rebooting, even if it is rebooting after a regular
Maintain and Monitor the Switch 94 User Manual