PA-5400 Series Firewall Installaon
Connect Power to a PA-5400 Series Firewall
The following topics describe how to connect power to a PA-5450 firewall. Before proceeding,
read
Determine PA-5400 Series Firewall Power Configuraon Requirements
understand the available power opons and that you provide enough power to the firewall based
on your configuraon. Aer you power on the firewall, you can
Power
Stascs.
Learn how to
Set Up a Connecon to the Firewall
powering on the firewall for the first me.
•
Connect AC or DC Power to a PA-5450 Firewall
Determine PA-5400 Series Firewall Power Configuraon
Requirements
At least one acve AC or DC power supply is required to operate a PA-5400 Series firewall.
Factors that can change your power requirements are the number of Networking Cards (NCs) and
Data Processor Cards (DPCs) used and your power redundancy requirement.
To determine the number of acve power supplies required to operate the appliance, refer to
PA-5400 Series Power Supply Chart
the column that coincides with the number of installed DPCs. Each power supply requirement in
the table accounts for the installaon of 1 or 2 NCs. To provide full redundancy, install double the
minimum number of power supplies specified in the table. A fully redundant power configuraon
means that half of the installed power supplies can fail and the appliance and installed NCs and
DPCs will sll funcon.
Table 1: PA-5400 Series Power Supply Chart
Model and Power Input
PA-5450 Firewall 110/120VAC
PA-5450 Firewall 240VAC or
-48VDC
All power supply requirements in the table above account for 1 or 2 NCs being installed in
the appliance.
You can find power informaon for hardware components in
Electrical
Specificaons. To view power stascs on an acve firewall, see
Firewall Power
Stascs.
Aer you determine the power requirements for your firewall, see
Series Firewall
and select the topic for your model and power type.
PA-5400 Series Next-Gen Firewall Hardware Reference
based on your desired boot mode prior to
and locate your model and power input type and then locate
Front Cards Installed and Acve Power Supplies Required
1 DPC
2 DPCs
2
2
1
1
50
to ensure that you
View PA-5400 Series Firewall
3 DPCs
4 DPCs
3
3
2
2
PA-5400 Series Firewall Component
View PA-5400 Series
Connect Power to a PA-5400
2021 Palo Alto Networks, Inc.
©
5 DPCs
3
2