Warnings - Graco EcoQuip 2 Vapor Abrasive Blast System Operation, Repair, And Parts

Warnings

Warnings Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific
risks. When these symbols appear in the body of this manual or on warning labels, refer back to these
Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout
the body of this manual where applicable.
SPECIAL CONDITIONS CONDITIONS FOR
SPECIAL SPECIAL CONDITIONS
• Ground all equipment in the work area. See Grounding
• All label and marking material must be cleaned with a damp cloth (or equivalent).
DUST AND AND DEBRIS
DUST DUST AND
Use of this equipment can result in the release of potentially harmful dust or toxic substances
from the abrasive being used, the coatings being removed, and the base object being blasted.
• For use only by sophisticated users familiar with applicable governmental safety and industrial
hygiene regulations.
• Use equipment only in a well-ventilated area.
• Wear a properly fit-tested and government approved respirator suitable for the dust conditions.
• Follow local ordinances and/or regulations for disposal of toxic substances and debris.
PRESSURIZED EQUIPMENT
PRESSURIZED PRESSURIZED
Fluid from the equipment, leaks, or ruptured components can splash in the eyes or on skin
and cause serious injury.
• Follow the Pressure Relief Procedure when you stop spraying/dispensing and before
cleaning, checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.
3A3489E
All manuals and user guides at all-guides.com
WARNING WARNING WARNING
FOR SAFE SAFE USE USE (ATEX
FOR SAFE USE
DEBRIS HAZARD HAZARD
DEBRIS HAZARD
EQUIPMENT HAZARD HAZARD
EQUIPMENT HAZARD
(ATEX systems systems only) only)
(ATEX systems only)
Grounding Instructions Instructions.
Grounding Instructions
Warnings
5