Using The Wash Feature - Graco EcoQuip 2 Vapor Abrasive Blast System Operation, Repair, And Parts

Operation
Using Using the Using the Wash the Wash Feature Wash Feature Feature
The wash feature uses water (without abrasive) to
rinse areas that have been blasted with abrasive. It is
also a convenient feature for flushing abrasive from
the blast hose.
NOTICE NOTICE NOTICE
There will always be some residual abrasive in
the blast hose. Never use the wash feature on
any surface other than where you have blasted, or
intend to blast. It will affect/dull the surface.
NOTICE NOTICE NOTICE
Do not use the wash feature on wood that has
been blasted. It could damage the wood and cause
the grain to rise. Wait for the wood to dry and then
use a broom, brush, or vacuum to remove any
residual abrasive.
20
All manuals and user guides at all-guides.com
1. Close the abrasive ball valve (M).
2. Turn the selector valve to WASH.
3. Blast 1 – 2 minutes until the abrasive is cleared
4. The equipment is now ready to wash any
from the hose.
previously blasted surfaces.
3A3489E