Graco EcoQuip 2 Vapor Abrasive Blast System Operation, Repair, And Parts page 6

Warnings
EQUIPMENT MISUSE EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Do not use this equipment without hose restraints and coupler pins installed on all air and
blast hose couplings.
• Do not blast unstable objects. The high amount of fluid flow from the nozzle can potentially
move heavy objects.
• Do not exceed load rating of lift eyes.
• Do not operate equipment on or stand on an unstable support. Keep effective footing and
balance at all times.
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical
Specifications in all equipment manuals. Read fluid and solvent manufacturer's warnings.
Specifications Specifications
For complete information about your material, request Safety Data Sheets (SDSs) from
distributor or retailer.
• Never use 1, 1, 1-trichloroethane, methylene chloride, other halogenated hydrocarbon
solvents or fluids containing such solvents in pressurized aluminum equipment. Such use
could result in a chemical reaction, with the possibility of explosion.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
BURN BURN BURN HAZARD HAZARD HAZARD
Equipment surfaces and fluid that is heated can become very hot during operation. To avoid
severe burns:
• Do not touch hot fluid or equipment.
FIRE FIRE AND FIRE AND EXPLOSION AND
Flammable fumes, such as solvent, in work
and explosion:
• Use equipment only in well ventilated area.
• Abrasive material exiting blast nozzle can generate sparks. When flammable liquids are used
near the blast nozzle or for flushing or cleaning, keep the blast nozzle at least 20 feet (6
meters) away from explosive vapors.
• Ground all equipment in the work area. See Grounding
• Keep work area free of debris, including solvent, rags and gasoline.
• Keep a working fire extinguisher in the work area.
6
All manuals and user guides at all-guides.com
WARNING
WARNING WARNING
MISUSE HAZARD MISUSE HAZARD HAZARD
Technical Specifications Technical
EXPLOSION HAZARD EXPLOSION HAZARD HAZARD
Specifications in all equipment manuals. Specifications
Pressure Relief Pressure Relief Procedure Relief Procedure when equipment is not in use. Procedure
work area work area can ignite or explode. To help prevent fire area
Grounding instructions (ATEX systems only).
Grounding
Technical
Technical
3A3489E