Setting Up The Equipment - Graco EcoQuip 2 Vapor Abrasive Blast System Operation, Repair, And Parts

Table of Contents

Operation

Setting Up

Up the

the Equipment

Equipment

Setting

the

Equipment

1. Fill the water tank with fresh water only, then

open the inlet ball valve (N).

2. Close the rinse ball valve (X) and abrasive ball

valve (M). Close the water dose meter (S) if

equipped.

3. Turn the selector valve to OFF.

All manuals and user guides at all-guides.com

4. Disengage the emergency stop (Q).

5. Align the pop-up handle with the pin slot, and

6. Open the pot dump valve (J).

NOTE: The water pump will not work unless the

NOTE:

Emergency Stop is disengaged.

then firmly push and turn the handle 90° after the

pin is below the bracket slot. Proper engagement

of the pin will hold the pop-up down until it is

released.

3A3489E

Table of Contents