Fluke CableAnalyzer DSP-4000 Series User Manual page 198

DSP-4000 Series
Users Manual
Viewing Your Project Data
Figure B-3 describes the basic features of the CableManager project window.
1
2
3
4
A
The command menus and toolbar give you access to CableManager commands.
B
The Autotest summary list shows the summary data for the reports in the project. Results
from the selected reports are shown in the lower half of the display.
A scroll bar appears at the right of this area if the list is longer than what is visible.
To resize a column in the list, drag the border in the heading row left or right.
C
The row of tabs shows the tests run for the Autotest report selected in the summary list. Click
on a tab to view the test results.
D
Test results for the selected tab are shown in this area. Where applicable, results from the
main unit are shown on the left side and results from the remote are shown on the right side.
For a DSP-4100 test tool, if STORE PLOT DATA was enabled when you ran the Autotest,
you can click on
B-8
Plot
to see a plot of the test data.
Figure B-3. The CableManager Project Window
oy80c.eps