Table of Contents
Advertisement
transmitters. Comply with the legal require-
ments for add-on parts.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial con-
nections intended for use with the basic wiring.
Be sure to observe the manufacturer's addi-
tional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or aerial positions
must be approved by Mercedes-Benz.
The maximum transmission output (PEAK) at the
base of the aerial must not exceed the following
values:
Waveband
Short wave
3 - 54 MHz
4 m waveband
74 - 88 MHz
2 m waveband
144 - 174 MHz
Trunked radio/Tetra
380 - 460 MHz
70 cm waveband
400 - 460 MHz
Mobile communications
(2G/3G/4G)
The following can be used in the vehicle without
restrictions:
RF transmitters with a maximum transmis-
R
sion output of up to 100 mW
RF transmitters with transmitter frequencies
R
in the 380 - 410 MHz waveband and a maxi-
mum transmission output of up to 2 W
(trunked radio/Tetra)
Mobile telephones (2G/3G/4G)
R
There are no restrictions when positioning the
aerial on the outside of the vehicle for the fol-
lowing wavebands:
Trunked radio/Tetra
R
70 cm waveband
R
2G/3G/4G
R
Identification plates
Vehicle identification plate with vehi-
cle identification number (VIN)
Maximum
transmission
output
X
100 W
30 W
50 W
10 W
35 W
10 W
Example: vehicle identification plate
:
;
=
?
A
B
C
i
Identification plates
Open the right-hand door.
You will see vehicle identification plate :.
Vehicle manufacturer (Daimler AG)
EU type approval number (only for certain
countries)
VIN
Maximum permissible gross vehicle weight
(kg)
Maximum permissible front axle load (kg)
Maximum permissible rear axle load (kg)
Paint code
The data shown on the vehicle identification
plate is example data. This data is different for
every vehicle and can deviate from the data
shown here. You can find the data applicable
to your vehicle on the vehicle's identification
plate.
321
Z
Advertisement
Table of Contents
