Table of Contents
Advertisement
Important safety notes
G
WARNING
Adaptive Highbeam Assist Plus does not rec-
ognise road users:
who have no lights, e.g. pedestrians
R
who have poor lighting, e.g. cyclists
R
whose lighting is blocked, e.g. by a barrier
R
In very rare cases, Adaptive Highbeam Assist
Plus may not recognise road users who do
have lights, or may recognise them too late. In
this, or in similar situations, the automatic
main-beam headlamps will not be deactivated
or will be activated despite the presence of
other road users. There is a risk of an acci-
dent.
Always carefully observe the traffic conditions
and switch off the main-beam headlamps in
good time.
Adaptive Highbeam Assist Plus cannot take into
account road, weather or traffic conditions.
Adaptive Highbeam Assist Plus is only an aid.
You are responsible for adjusting the vehicle's
lighting to the prevailing light, visibility and traf-
fic conditions.
In particular, the detection of obstacles can be
restricted if there is:
poor visibility, e.g. due to fog, heavy rain or
R
snow
dirt on the sensors or if the sensors are
R
obscured
Switching Adaptive Highbeam Assist
Plus on/off
To switch on: turn the light switch to Ã.
X
Press the combination switch beyond the
X
pressure point in the direction of arrow :.
The _ indicator lamp in the multifunction
display lights up when it is dark and the light
sensor switches on the dipped-beam head-
lamps.
At speeds above approximately 25 km/h:
the headlamp range is automatically control-
led according to the distance to other road
users.
At speeds above approximately 30 km/h:
if no other road users are detected, the
R
main-beam headlamps are automatically
switched on
if other road users are detected, the partial
R
main-beam headlamps are automatically
switched on
The K indicator lamp in the instrument
cluster also lights up.
At speeds below approximately 25 km/h
or when there is sufficient street lighting:
the partial main-beam headlamps are
R
switched off automatically
the main-beam headlamps are switched off
R
automatically
The K indicator lamp in the instrument
cluster goes out. The _ indicator lamp in
the multifunction display remains lit.
To switch off: move the combination switch
X
back to its normal position or move the light
switch to another position.
The _ indicator lamp in the multifunction
display goes out.
Interior lighting
Overview of interior lighting
Overhead control panel
p Switches the left-hand reading lamp
:
on/off
;
c Switches the interior lighting on
=
| Switches the interior lighting/auto-
matic interior lighting control off
p Switches the right-hand reading lamp
?
on/off
A
Switches the automatic interior lighting con-
trol on
Interior lighting
Z
117
Advertisement
Table of Contents
