Table of Contents
Advertisement
Features
270
When programming a garage door opener, park
the vehicle outside the garage. Do not run the
engine while programming.
The garage door opener is only available for cer-
tain countries. Observe the legal requirements
for each individual country.
®
The HomeLink
ible with most European garage and gate opener
drives. More information on HomeLink
compatible products is available:
at a qualified specialist workshop
R
via the HomeLink
R
(0) 08000 466 354 65 or alternatively
+49 (0) 6838 907-277
on the Internet at http://www.homelink.com
R
Important safety notes
G
WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G
WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(
page 270).
Y
garage door opener is compat-
®
®
Hotline
and/or
Garage door remote control A is not included
with the integrated garage door opener.
Turn the key to position 2 in the ignition lock
X
(
page 132).
Y
Select one of buttons ; to ? to control the
X
garage door drive.
To start programming mode: press and
X
hold one of buttons ; to ? of the integrated
garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp : begins to light up yellow.
Indicator lamp : lights up yellow immedi-
ately the first time button ;, = or ? is pro-
grammed. If the selected button has already
been programmed, indicator lamp : lights
up yellow after ten seconds have elapsed.
Release button ;, = or ?. Indicator
X
lamp : flashes yellow.
To program the remote control: point
X
garage door remote control A towards but-
tons ; to ? on the rear-view mirror at a dis-
tance of 5 to 20 cm.
Press and hold button B on remote control
X
A until indicator lamp : lights up green.
When indicator lamp : lights up green: pro-
gramming is finished.
When indicator lamp : flashes green: pro-
gramming was successful. The next step is to
synchronise the rolling code (
Release button B of remote control A of the
X
garage door drive.
If indicator lamp : lights up red: repeat the
programming process for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A and the rear-view mirror.
The required distance between remote con-
trol A and the integrated garage door opener
depends on the garage door drive system.
page 271).
Y
Advertisement
Table of Contents
