Table of Contents
Advertisement
Control panel for THERMOTRONIC automatic climate control (2-zone)
To set the temperature, left (
:
To set climate control to automatic mode (
;
To demist the windscreen (
=
To switch the residual heat on/off (
?
To activate/deactivate cooling with air dehumidification (
A
B
To switch the rear window heating on/off (
C
To switch the ZONE function on/off (
D
To set the temperature, right (
E
To switch the climate control on/off (
To set the air distribution (
F
To set the airflow (
G
To set the climate mode (
H
To activate/deactivate air-recirculation mode (
I
Information on using THERMOTRONIC
automatic climate control
Automatic climate control
The following contains instructions and recom-
mendations to enable you to get the most out of
your THERMOTRONIC automatic climate con-
trol.
Activate climate control using the à and
R
¿ buttons on the climate control panel.
The indicator lamps in the à and
¿ buttons light up.
In automatic mode, the ñ button on the
R
climate control panel may be used to addi-
tionally adjust the airflow (FOCUS/MEDIUM/
Overview of climate control systems
page 125)
Y
page 126)
Y
page 129)
Y
page 126)
Y
page 125)
Y
page 124)
Y
page 126)
Y
page 126)
Y
page 125)
Y
page 125)
Y
page 124)
Y
page 127)
Y
page 128)
Y
DIFFUSE). The MEDIUM level is recommen-
ded.
Set the temperature to 22 †.
R
Only use the "Windscreen demisting" function
R
briefly until the windscreen is clear again.
Only use air-recirculation mode briefly, e.g. if
R
there are unpleasant outside odours or when
in a tunnel. The windows could otherwise mist
up as no fresh air is drawn into the vehicle in
air-recirculation mode.
Use the ZONE function to adopt the temper-
R
ature settings on the driver's side for the
front-passenger side as well. The indicator
lamp in the á button goes out.
Use the residual heat function if you want to
R
heat or ventilate the vehicle interior when the
ignition is switched off. The residual heat
123
Advertisement
Table of Contents
