Mercedes-Benz SL 2015 Owner's Manual page 258

Table of Contents

Advertisement

Select a favourite.
X
Add a favourite at the desired position.
X
If a favourite has already been added at this
position, it will be overwritten.
Adding your own favourite
Select
Vehicle
VehicleQClimate control
Climate
X
Press and hold the ò button until the
X
favourites are displayed.
Add a favourite at the desired position.
X
If a favourite has already been added at this
position, it will be overwritten.
Navigation mode
Important safety notes
G
WARNING
Operating the integrated information systems
and communications equipment in the vehicle
while driving will distract you from traffic con-
ditions. You could then lose control of the
vehicle. There is a risk of an accident.
Only operate these devices if road traffic con-
ditions permit. If you are unsure about the
surrounding conditions, pull over to a safe
location and make entries only while the vehi-
cle is stationary.
You must observe the legal requirements for the
country in which you are currently driving when
operating the navigation system.
General notes
Correct functioning of the navigation system
depends, amongst other things, on GPS recep-
tion. In certain situations, GPS reception may be
impaired, there may be interference or there
may be no reception at all, e.g. in tunnels or
multi-storey car parks.
Audio 20 is equipped with Garmin
(see the manufacturer's operating instructions).
®
The Garmin
MAP PILOT operating instructions
are stored on the SD memory card as a PDF file.
The SD card box contains a quick guide.
The following descriptions apply to navigation
with COMAND Online. Further information can
be found in the Digital Owner's Manual.
Selecting a route type and route options
Multimedia system:
Select
X
The map displays the current vehicle position.
Slide 6 the controller.
X
control.
Select
X
Notes for route types:
Eco route
Eco route
R
Dynamic route
Dynamic route
R
Traffic reports on the route for the route guid-
ance are taken into account.
Dynamic route only after request
Dynamic route only after request
R
You can decide whether or not current traffic
reports should be taken into account for route
calculation.
Calculate alternative routes
Calculate alternative routes
R
Different routes are being calculated. In order
to do so, instead of
item
Notes for route options:
Use toll roads
Use toll roads
R
The route calculation includes roads which
require you to pay a usage fee (toll).
Use vignette roads
Use vignette roads
R
countries)
The route calculation includes roads which
require you to pay a time-based fee (vignette).
A vignette allows temporary use of the route
network, e. g. 10 days or 1 year.
Entering an address
Multimedia system:
Select
X
The map displays the current vehicle position.
Slide 6 the controller.
X
Select
X
Enter an address, e.g. as follows:
town or postcode, street, house number
R
country, town or postcode
®
R
MAP PILOT
town or postcode, centre
R
street, town or postcode, junction
R
Select
X
The town in which the vehicle is currently
located (current vehicle position) is at the top.
Below this, you will see locations for which
route guidance has already been carried out.
Operating system
NaviQNavigation
Navi
Navigation.
OptionsQRoute settings
Options
Route
settings.
Start
Start, select the menu
Continue.
Continue
(not available in all
Navi
NaviQNavigation
Navigation.
Destination
DestinationQAddress entry
Address
Town
Town.
255
entry.
Z

Advertisement

Table of Contents
loading

Table of Contents