Taylor 142 Operating Instructions Manual page 12

Slide the front bearing over the baffle rod so the
flanged edge is against the door. Place the white
plastic guide bearing on the end of the baffle rod. Do
not lubricate the front bearing or guide bearing.
Figure 6
Step 3
Install the freezer door. Insert the handscrews into the
slots in the freezer door. With both hands holding the
sides of the freezer door, insert the baffle rod into the
center of the beater assembly. The white guide bearing
must fit securely in the hole of the drive shaft.
Finger‐tighten the handscrews equally to ensure that
the door is snug. Do not over‐tighten.
Note: The freezer door is in the correct position when
the door spout is on the bottom.
Figure 7
Operating Procedures
Step 4
Install the draw valve. Slide the two o‐rings into the
grooves on the draw valve and lubricate with Taylor
Lube.
Lubricate the inside of the door spout from the bottom.
Insert the draw valve into the freezer door from the
bottom.
8
Figure 8
Figure 9
Model 142