Indicator Light - Mix Low; Standby Switch; Reset Mechanism; Temperature Adjustments - Taylor 142 Operating Instructions Manual

Indicator Light - MIX LOW

A mix level indicating light is located on the front of the
machine. When the light is on, it indicates that the mix
hopper has a low supply of mix. The hopper should be
refilled immediately. Always maintain at least 2" (5.1
cm.) of mix in the hopper. If mix is not added to the
hopper, the freezing cylinder may freeze. This will
cause damage to the beater assembly and to the
freezer door.

Standby Switch

This push button switch determines which mode of
operation the freezing cylinder is operating in. If the
center button of this switch is in the "OUT" position and
it is not illuminated, the unit will operate in the normal
product dispensing mode when the toggle switch is
placed in the AUTO position.
If the center button of the standby switch is in the "IN"
position and is illuminated, the machine will operate in
the STANDBY mode when the toggle switch is placed
in the AUTO position.

Reset Mechanism

Should an overload condition occur, the freezer will
automatically shut down. To properly reset the freezer,
place the toggle switch in the OFF position. Wait two
or three minutes; then press the reset button located
in the side panel. Place the toggle switch in the WASH
position and observe the freezer's performance; return
the toggle switch to the AUTO position.
Important: To the Operator

Temperature Adjustments

Temperature adjustments should be performed only
by an authorized Taylor Service Representative.

Feed Tube

The feed tube meters a combination of mix and air into
the freezing cylinder. If mix is not added to the hopper,
the freezing cylinder may freeze. This will cause
damage to the beater assembly and to the freezer
door. Depending upon the product being run, you may
wish to contact your local authorized Taylor Distributor
to make a slight adjustment in the feed tube.
When the unit is operating in the AUTO mode, the
metering hole should be placed in the downward
position. When the unit is placed in the STANDBY
mode, the tube should be inverted.
6
Figure 2
Model 142