Alphatech IP-VarioBell Installation And Operating Instructions Manual page 59

then you must not forget to dial code 10 when you actually leave. These codes
are of course selected from your phone, in conjunction with the door
Communicator
2. Switch 1 switches 2 pulses per command:
Set the same code as in the
previous example.
Relay switching time: 1sec
Time between impulses: 6sec (
of relay switching from 7sec
synchronization delay)
Note: Switch 1 synchronizes with itself.
3. Automatic gradually switching on switches 1 and next switch 2 on one
command - the door behind
This is actually a combination of two previous cases:
Switch 1 is set according to example 1 and switch 2 is set according to
example 2.
Note: Switch 2 is synchronized with switch 1.
The code for switch 1 control automatically activates switch 2 for 7 seconds.
The codes for switch 2 control only switch 2.
4. The switch is permanently switched on during a call in time limited by
the "work"
Note: In the "Activate on call" setting, you can choose whether the switch is
switched on every time you make a call, or only when you receive a call or just
when you make an outgoing call.
IP VarioBell
- installation and operating instructions
1sec
59