Připojení Ip-Vario Bell; Ip-Variobell Základní Deska - Alphatech IP-VarioBell Installation And Operating Instructions Manual

1.4 Conecting the IP-VarioBell
The IP-VarioBell doorphone consists of a motherboard, a processor
board and is always equipped with two call buttons. How many call buttons will
be used at the installation site is determined only by the front panel (0, 1 or 2
call buttons). Additional call button modules of up to 85 call buttons, including
the keyboard, can be connected to the motherboard. Furthermore, the
motherboard is equipped with two inputs (door sensors or exit buttons which
need to be HW specified in the production based on your purchase order) and
two relay switches (relays).
1.4.1 IP-VarioBell motherboard
The motherboard is the same for all IP-VarioBell models and only
differs in the installation of the camera module. As standard, it is equipped with
a PoE module (according to the IEEE802.3af standard), a connector for
connecting expansion modules, LED name-card backlight, a microSD card
reader and two relay switches.
All functional and connecting elements are marked with a number in a
red circle.
1. CPU board (processor module)
2. LED green - the power supply of the doorphone is OK
3. LED for network activity control, green = 100M LAN connection, yellow =
data transmission to LAN
4. MicroSD card slot - insert the card before switching on the door intercom
and it must not be ejected during the whole operation!
5. DIP switch
– always ON (used for service purposes only)
1
– OFF; if switched to ON before start, the
2
intercom sets to the default IP addresss
192.168.1.250 and to the default/empty style. The name is
and the password is 1234. To display video, the name is
and the password
operation of the intercom is OFF.
6. UTP cable connection (Ethernet, LAN, network)
7. Two inputs (middle terminal is common to both) for door sensors or exit
buttons (programmable)
8. Cable connection K0 for expansion module(s) - flat cable, orange
connector on one side and black connector on the other side
9. Terminal block of the changeover contact of the first relay (NC = normally
closed, NO = normally open and COM = common, middle terminal)
10. Terminal block of the changeover contact of the second relay NO = open
at rest and COM = common, middle terminal)
14
1234 (if requested). The standard position for
IP VarioBell
- installation and operating instructions
admin
video