Real World Command Use - CYP CPLUS-662CVEA Operation Manual

• Complex Multi-Port/Parameter Command Format
It is possible to have a single command that affects multiple ports with
multiple groupings of parameters. All previously explained syntax rules
must be observed and each additional set of ports/parameters are
separated by the "&" character.
<Command> {Port1}+{Port2}+{Etc.} {Param1 [= Value]}, {Param2 [=
Value]}, {Etc.} & {Port1}+{Port2}+{Etc.} {Param1 [= Value]}, {Param2 [=
Value]}, {Etc.} & Etc.
Example:
HDBT_Out A+C+E VideoSrc=HDMI_In 2, AudioSrc=CoaxIn 1 & B+D Mute
& F VideoSrc=HDMI_In 1, AudioSrc=HDMI_In 1
• Complex Multi-Slot/Parameter Command Format (ZoneAvPair)
The ZoneAvPair command can also control multiple slots with multiple
parameter groupings however the syntax is slightly different. Each
command can only affect a single port at a time. Each additional set
of slots/parameters are separated by the "&" character.
ZoneAvPair HDBT_Out {Port} Slot {Slot1}+{Slot2}+{Etc.} {Param1=Value},
{Param2=Value} & Slot {Slot1}+{Slot2}+{Etc.} {Param1=Value},
{Param2=Value} & Etc.
Example:
ZoneAvPair HDBT_Out B Slot 1 VideoSrc=HDMI_In 2, AudioSrc=CoaxIn
1 & Slot 2+3+4 VideoSrc=HDMI_In 2, AudioSrc=AnalogIn 1 & Slot 5+6
VideoSrc=HDMI_In 1, AudioSrc=HDMI_In 1 & Slot 1 Load

6.8.2 Real World Command Use

• Zone A/V Pairing Mode Command Example
The easiest way to use the matrix for simple HDMI switching while still
allowing for individually tailored zone audio is to use the Zone A/V
Pairing setting within the WebGUI.
This is a configured and saved setting allowing each HDMI input to
be paired with different audio inputs, depending on the zone it is
being output to, for easy selection from a remote within that zone. For
example, certain zones might not be able to handle surround sound,
so you can pair the video in that zone with stereo inputs. Please review
to section 6.10.6 for details of Zone A/V Pairing configuration.
14