Remote Control - CYP CPLUS-662CVEA Operation Manual

6.4 Remote Control

POWER: Press to power the unit on or place it
1
into stand-by mode.
2 LOCK: Press to lock/unlock the front panel of
the matrix unit.
MUTE: Mutes Zone Audio outputs. HDBaseT
3
audio can only be muted when an
independent, non-HDMI, audio source has
been routed to the output.
IN 1~6, OUT A~H & PATTERN:
4
[Local matrix control]: When controlling the
unit directly. Input selection from 1~6 plus
test patterns (pattern button) and output
selection from A~H (refer to section 6.1).
[Zone A/V Pairing]: When controlling the unit
via an HDBaseT receiver in a remote location.
Pressing buttons 1~6 will switch to the A/V
source assigned to the number depending
on your current zone. These assignments are configured via the
WebGUI (refer to section 6.10.6).
MENU/CANCEL: Press the "MENU/CANCEL" button to enter the
5
OLED menu, or to back out from menu items.
PRESET: Recall matrix presets. The presets are configured within the
6
WebGUI.
7 +/IN: Within the menu, this button moves you up within the menu
tree. Otherwise, in routing mode, this button allows you to make
your input source selection.
-/OUT: Within the menu, this button moves you down within the
menu tree. Otherwise, this button starts routing mode and allows
you to begin your output destination selections.
◄/VOL- & ►/VOL-: Adjust volume of zone audio.
ENTER: Press this button to confirm selections.
Note: This remote control is designed for the full family of matrix
products. Some functions are not available on all units.
MUTE LOCK POWER
3
1/A 2/B 3/C
4/D 5/E 6/F
7/G 8/H 9/I
10/J PATTERN
MENU/
CANCEL +/IN PRESET
5
/VOL- ENTER /VOL+
-/OUT
CR-163
1
2
4
6
7
9