Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [INFO MONITOR SETTING] screen is displayed.
3)
Press as to select [BRIGHTNESS].
4)
Press qw to adjust the level.
Operation
Press w.
Press q.
Note
f [BRIGHTNESS] is adjusted in increments of 10.
f This can also be set with operation in the information monitor. For details, refer to "Using the information monitor function" (x page 213).
[DATA CLONING]
Perform the operations of the data cloning function. Data such as the settings and adjustment values of the
projector can be copied to multiple projectors via LAN or using the USB memory.
For details of operation, refer to "Using the data cloning function" (x page 225).
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1)
Press as to select [SAVE ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The confirmation screen is displayed.
4)
Press qw to select [OK], and press the <ENTER> button.
f [PROGRESS] is displayed while saving data.
Note
f The data saved by executing [SAVE ALL USER DATA] does not include the data set with "Geometric & Setup Management Software".
f The data saved by executing [SAVE ALL USER DATA] is not deleted even if initialized by any of the following methods.
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1)
Press as to select [LOAD ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The confirmation screen is displayed.
4)
Press qw to select [OK], and press the <ENTER> button.
Note
f The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f The data loaded from [LOAD ALL USER DATA] does not include the data set with "Geometric & Setup Management Software".
150 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
The information monitor becomes bright.
The information monitor becomes dark.
Adjustment
Range of adjustment
30 % - 100 %
(Factory default setting: 100 %)
Advertisement
Table of Contents
