[Data Cloning] - Panasonic PT-MW630 Operating Instructions Manual

[SIGNAL INFORMATION]
*1 The temperature status is indicated with text color (green/yellow/red) and bar scale. Use the projector within the range that the indication is
green.
Note
f E-mail containing the status can be sent to the E-mail address (up to two addresses) set in "[E-mail set up] page" (x page 171) by
pressing the <ENTER> button while the [STATUS] screen is displayed.
f There may be items that are displayed and items that are not displayed in [SIGNAL INFORMATION] depending on the setting or the input
signal.
f If any abnormality has occurred on the projector, press the <DEFAULT> button while the [STATUS] screen is displayed to display the detail
screen of the error information.
f For details on the contents displayed in [SELF TEST], refer to "[SELF TEST] display" (x page 207).

[DATA CLONING]

The menu setting and adjustment values of one projector can be copied to multiple projectors via LAN or using
the USB memory.
r Data that cannot be copied
Following menu settings and adjustment values are not copied. Set these in each projector.
f Menu lock password
f Security password
f Control device password
f The [PROJECTOR SETUP] menu → [PROJECTOR ID]
f The [PROJECTOR SETUP] menu → [DATE AND TIME] → [ADJUST CLOCK]
f [NETWORK/USB] → [WIRED LAN]
f [NETWORK/USB] → [WIRELESS LAN]
f [NETWORK/USB] → [PROJECTOR NAME]
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [LAN] → [WRITE PROTECT]
f Password set in "[Change password] page" (x page 175) of the web control screen
f "[E-mail set up] page" (x page 171) in the web control screen
f "[Authentication set up] page" (x page 172) in the web control screen
f "[Crestron Connected(TM)] page" (x page 176) in the web control screen
r Supported device
f Commercially available USB memory is supported.
The USB memory with a security function is not supported.
f Only the cards formatted in FAT16 or FAT32 can be used.
f Only the single partition structure is supported.
Note
f The cloning function will not operate when the models of the projectors are different. Use between the same model.
f Set the input to anything other than MEMORY VIEWER, and then execute [DATA CLONING].
f When the data cloning function is used, the light source indicator <LIGHT>, the temperature indicator <TEMP>, and the filter indicator
<FILTER> will blink while copying the data. Wait until the blinking of the indicator is stopped.
Copying the data to other projector via LAN
Set the projector to copy the data as follows in advance.
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [LAN] → [WRITE PROTECT] → [OFF]
Chapter 4 Settings — [PROJECTOR SETUP] menu
[INPUT]
[SIGNAL FORMAT]
[SIGNAL FREQUENCY]
[SYNC.STATE]
[V.SYNC WIDTH]
[SCAN TYPE]
[TOTAL DOTS]
[DISPLAY DOTS]
[TOTAL LINES]
[DISPLAY LINES]
[SAMPLING]
[SIGNAL LEVEL]
Displays the input terminal used for the projected image.
Displays the format of the input signal.
Displays the frequency of the input signal.
Displays the sync polarity of the input signal.
Displays the vertical sync signal pulse width of the input signal.
Displays the scan type of the input signal.
Displays the total dot count of the input signal.
Displays the number of input signal display dots.
Displays the total line count of the input signal.
Displays the number of input signal display lines.
Displays the sampling information of the input signal.
Displays the signal level of the input signal.
ENGLISH - 127