Using The Field Communicator; Using Amsr Wireless Configurator Or Ams Device Manager; Installation - Emerson TopWorx 4310 Instruction Manual

Instruction Manual
October 2009
OVERVIEW
Figure 2. Join Device to Network

Using the Field Communicator

1. Verify the Field Communicator has the 4310
device description (DD) loaded.
2. Obtain the Network ID and Join Key from the
1420 gateway via web interface. Go to Setup, then
select Network. The Network ID will be shown. Click
"Yes" to see the Join Key.
3. Open the cover of the 4310 and attach the Field
Communicator leads to the 4310 HART
(see figure 22).
4. Select Online, Overview, Shortcuts, then Join
Device to Network to enter the network parameter
settings (see figure 15 for the Overview menu tree).
5. Remove the leads from the 4310 and close the
cover.
6. Install the 4310 on monitored equipment and/or
verify the 1420 gateway.
Using AMS Wireless Configurator or
AMS Device Manager (Using a HART
Modem)
1. Verify that AMS has the 4310 DD loaded.
2. Obtain the Network ID and Join Key from the
1420 gateway via web interface. Go to Setup, then
select Network. The Network ID will be shown. Click
"Yes" to see the Join Key.
3. Open the cover of the 4310 and attach the HART
modem leads to the HART terminals (see figure 22).
4310 Wireless Position Monitor
JOIN DEVICE
TO NETWORK
R
terminals
4. In AMS select the device that is connected to the
HART modem. Select Online, Overview, then Join
Device to Network (see figure 2).
5. Remove the leads from the 4310 and close the
cover.
6. Install the 4310 on monitored equipment and/or
verify the 1420 gateway.

Installation

WARNING
Before mounting the 4310 wireless
position monitor:
D Always wear protective clothing,
gloves, and eyewear when performing
any installation procedures to avoid
personal injury or property damage.
D Check with your process or safety
engineer for any additional measures
that must be taken to protect against
process media.
WARNING
Due to the combustible nature of the
lithium content, the power module has
special installation, operation, storage,
and/or shipping requirements.
Observe all warnings included with the
power module before installing,
operating, storing, or shipping the
4310 position monitor. Failure to do so
may result in personal injury or
property damage from fire or
explosion.
CAUTION
When installing components, proper
means of electrostatic discharge
protection is required. Failure to use a
grounding strap, or other means of
electrostatic discharge protection can
result in damage to the electronics.
5