Cleaning, Care And Maintenance; Replacing The Battery - Kompernass KH 6002 Operating Instructions Manual

Cleaning, care and maintenance

Caution!
Do not use strong, abrasive or corrosive deter-
gents/cleaners or solvents! Prevent moisture from en-
tering the computer!
1. Clean the device at least once a week using a
soft cloth (if necessary, the cloth can be slightly
moistened).
2. If squeaking sounds occur, grease the moving be-
arings and axle connections with hub and bea-
ring grease (obtainable from bicycle dealers).
3. Before every training session, please check the
stepper for possible damage or signs of wear.
Pay particular attention to the plastic washers in
the rod axles, to the pedal treads as well as to
the elastic ropes and rope fasteners. If a part is
faulty and needs to be replaced, the stepper
must not be used until the faulty part has been re-
placed.
4. Please pay attention to the following parts which
are subjected to greater wear due to the load
placed upon them:
- Plastic washers, part no. 25, 26, 31, 32, 34, 61
- Elastic ropes, part 47

Replacing the battery

If the display quality begins to fade, replace the bat-
tery with a new one of type „Micro (AAA/LR03).
1. Carefully lever and rotate the computer unit
out of the post.
2. Remove the battery carefully but with a little for-
ce. Start by pulling the battery out by its positive
terminal.
3. Insert a new battery by inserting its negative ter-
minal first. Make sure the polarity is correct! (see
"Assembling and setting up")
4. Insert the computer unit
(see "Assembling and setting up").
- 13 -
y
y
back into the post