Checks Before Starting Up Electromechanical Version; Check Before Starting The Electronic Version - ZANOLLI Citizen 6/MC Instructions For Installation, Use And Maintenance Manual

_______________________________________________________________5. INSTALLATION

5.6.Checks before starting up electromechanical version.

Turn on the main switch on the switchboard.
Turn on the switch (6.2.1.), program a temperature above 100-120 °C
(6.2.4.), set both the power regulators at 10.
Check that the current to each phase is that indicated in chapter 3., for the
corresponding feed voltage.
Set both the power regulators at 5 and check that their lights go on and off at
intervals.
Turn off the switches and the main switch on the board.

5.7.Check before starting the electronic version

Turn on the main switch on the control panel.
Turn on the ON/OFF light switch ON/OFF of the oven main system
(7.3.3.). Press the key , programme a temperature over 100-120 °C
(7.3.1.) and set the two values of the oven top and bottom powers to 9
(7.3.2.) and (7.3.4.).
Press the key , turn off the ON/OFF light switch of the oven main
system and the main switch on the control panel.
I
MPORTANT – PRE-HEATING PHASE AT FIRST IGNITION
The components of the brand new oven (refractory stone bottom and metal
parts) need to be pre-heated before being used for the first baking.
When the oven is switched on the first time, it is necessary to HEAT IT
GRADUALLY IN ABOUT 5-6 HOURS (1°h=100°C - 2-3°h=150°C -
4°h=200°C - 5°h=250°C - 6°h=300°C). The max temperature has to be
reached at the end of this pre-heating phase.
This procedure is absolutely necessary to avoid damages to any part of the
oven.
______________________________________________________________________________
15 CITIZEN 6 - 9/MC