Ctivity And Inactivity State; On/Off Of Main System; Settings; Setting Of Set-Temperature - ZANOLLI Citizen 6/MC Instructions For Installation, Use And Maintenance Manual

_______________________________________________7. WORKING ELECTRONIC VERSION
7.2.Activity and inactivity state
During the inactivity state the card is powered but no functions foreseen by
the system can be enabled, since the electromagnetic switch is not enabled
yet. The display
All keys on the push-button panel will be disabled, except for the key
(system ignition) and the key
By pressing the key
shown for about 5 seconds on the display
elapsed, the writing "OFF" will be displayed again.
By pressing the key
cycle is started, the values relating to the latest set-temperature which has
been set will appear on the display
before switching off the oven are shown on the displays
.

7.3.Settings

7.3.1.Setting of set-temperature

To set the desired set-temperature press the key
making sure that the display
programmed temperature.
Use the keys
the display.
Once the desired value has been reached, press the key
the datum into memory. The parameter is shown in fixed mode and the
display
can now proceed with setting the oven top and bottom power.

7.3.2.Setting of oven top

Press the key
element starts to blink showing the latest set parameter. Use the keys
and until you read the desired parameter on the display.
______________________________________________________________________________
21
of the control panel will show the writing "OFF".
.
the temperature inside the baking chamber will be
the system gets into the inactivity state, the baking
and until you read the desired baking temperature on
relating to the oven top heating element starts to blink. You
until the display
CITIZEN 6 - 9/MC

on/off of main system

and the parameters used
starts to blink showing the latest

and oven bottom power

relating to the oven top heating
; after this time has
, then the key
again to enter
and