Key Chamber Light; Switch For Suction Hood; Alarms; Overtemperature Alarm - ZANOLLI Citizen 6/MC Instructions For Installation, Use And Maintenance Manual

_______________________________________________7. WORKING ELECTRONIC VERSION
7.3.5.Key chamber light
By pressing the key of the chamber light
the lamp placed inside the baking chamber. By pressing it again, you
deactivate it.
7.3.6.

Switch for suction hood

The switch for suction hood control
is placed on the side part of the control
panel, on the upper side (Pos.1 of Fig. 7.2).
Push this switch on position "I" to start one of
the two motors of the suction hood.
Push this switch on position "II" to start both
motors of the suction hood.
Push this switch on position 0 to stop it.

7.4.Alarms

7.4.1.Overtemperature alarm

If the chamber exceeds 500°C owing to a failure, the system will block the
current cycle immediately.
The electromagnetic switch will inhibit the oven functions. The blinking writing
"tS1" will be shown on the display
To reset the alarm and enable the system again, press the key
after detecting the failure.
If you reactivate the oven operation before the temperature has fallen below
500°C, the alarm will appear again.
In any case have the oven checked by a technician to eliminate the cause for
the alarm before using the oven again.
7.4.2.Disconnected probe
When the probe is disconnected or interrupted, the blinking writing "tS1" is
shown on the display
To reset the alarm and enable the system again, press the key
after detecting the failure.
In any case have the oven checked by a technician to eliminate the cause for
the alarm before using the oven again.
______________________________________________________________________________
23
you activate the turning on of
.
.
CITIZEN 6 - 9/MC
Pos.1
Fig.7.2
twice
twice