Checking Before Starting Work - ZANOLLI TEOREMA POLIS PW Manual For Installation, Use And Maintenance

3. INSTALLATION
The Manufacturer cannot answer for damage caused by ignoring
these abovementioned norms as well as the information in this
manual.
To locate exhaust see Annex B

3.7. Checking before starting work

After completing installation of the unit a series of checks must be carried
out, listed as follows:
- check that the various disassembled parts have been assembled
- check the electrical power connections;
- check that the control panel is working
- If present, check that the ventilation hood is working
IMPORTANT – TURNING ON FOR THE FIRST TIME
The components of a factory new oven (cooking surfaces of refractory or
sheet metal material) need to be subjected to an initial preheating.
BRINGING THE OVEN UP TO TEMPERATURE OVER A PERIOD OF 5-
6 HOURS (1°h=100°C - 2-3°h=150°C - 4°h=200°C - 5°h=250°C -
6°h=300°C); the first time the oven is turned on this is an
INDISPENSIBLE procedure to avoid possible damage to the above
mentioned parts.
TEOREMA POLIS PW 13