Table of Contents
Advertisement
Info
On metered units, the "Treatment" step on the regeneration cycle wheel will flash
when water is flowing through the unit.
7
Backwash
8
Rapid Rinse
9
Treatment
10
Day and time
11
Next scheduled
regeneration
12
Tank Refill
13
Pause
14
Draw
15
Custom
16
Home
17
USB connect
18
Arrows
Info
Settings on previous screen are not saved unless
19
Alarm
20
Error
Ref. MKT-IM-038 / E - 22.10.2021
• Water flows from the bottom of the vessel to the top of the
vessel to clean and mix the media.
• Water flows from the top of the vessel to the bottom of the
vessel to rinse the media.
• The unit is treating water.
• Displays the currently programmed day of the week and time.
This button will flash at the start-up and if the supercapacitor
is discharged
• Displays the time to next scheduled regeneration, or volume
remaining until regeneration in meter systems.
• Brine tank is refilled with water.
• Valve comes back in service position to allow brine
preparation after refill. Shown if variable refill/brining
regeneration flow has been selected in master setting.
• Brine is drawn into the media and then slowly rinsed out.
• Shown if custom regeneration flow has been selected in
master setting.
• Displays the home screen.
• Allows you to connect the controller to a PC via a USB cable
for field programming or download of diagnostic parameters
via PC (Field Programmer application required).
• Displayed in the upper-left and upper-right corners of the
screen, these arrows allow you to navigate from one screen
to another.
• Allow you to change the values of certain settings when
programming the controller.
• Displayed when an error has occurred; accompanied with an
audible alarm. Press to silence the audible alarm.
• Displayed when an error has occurred. Press to display the
error screen for more detailed error information.
Installer manual Foleo 5800 XTR - Programming
is pressed.
39 / 108
Advertisement
Table of Contents
