Interface Description; Fig. 3 Cp37Xx-1600_Access To The Connection Compartment - Beckhoff CP37-1600 Series Manual

3.2

Interface description

In the basic configuration, the Panel PC includes the following interfaces:
• Power supply (X101)
• Ethernet RJ45 (X102)
• USB
The voltage socket and the Ethernet interface are located at the rear in the connection compartment of the
PC. The USB interface is located behind a screw cap in the side panel of the PC. To access the USB
interface, remove the screw cap from the housing.
If you have installed a mounting arm adapter on the Panel PC, you first have to gain access to the
connection compartment of the device. Follow the steps below, as shown in Fig. 3:
1. Use a screwdriver to reach into the recesses on the underside of the mounting arm adapter (section A).
2. Bend the cover slightly outwards so that you can push out the latching lugs.
3. Slide the cover upwards off the mounting arm adapter (section B).
ð You now have access to the connection compartment of the Panel PC (section C).
4. Then push the cover back onto the mounting arm adapter from top to bottom until the latching lugs snap
back into place.
A
Fig. 3: CP37xx-1600_access to the connection compartment
CP37xx-1600
B
Version: 1.1
Product overview
C
11