Fig. 14 Cp37Xx-1600_Orientation Of The Mounting Arm Adapter; Fig. 15 Cp37Xx-1600_Installing The Mounting Arm Adapter - Beckhoff CP37-1600 Series Manual

Fig. 14: CP37xx-1600_orientation of the mounting arm adapter
To fasten the mounting arm adapter to the Panel PC, follow the steps below, shown in Fig. 15:
1. Remove the cover of the mounting arm adapter (section A). For the exact procedure see chapter 3.2
Interface description [} 11].
2. Place the mounting arm adapter with the four M6 screws in front of the four M6 threaded holes at the
back of the Panel PC (section B).
A
Fig. 15: CP37xx-1600_installing the mounting arm adapter
3. Tighten the four M6 screws with a tightening torque of 4 Nm.
4. Replace the cover on the mounting arm adapter.
ð You have installed the mounting arm adapter on the Panel PC.
CP37xx-1600
B
Version: 1.1
Commissioning
25