Programming And Operation; Power Up The Keypad; Set Keypad Into Programming Mode With Master Code - AEI DK-2822 User Manual

PROGRAMMING & OPERATION
POWER-UP THE KEYPAD
The keypad gives power-up delay of 1 minute after power has been applied. It is the time frame
designed for setting the keypad to programming mode with DAP code. See the details of "DAP
CODE – 2 8 2 8" below.
1) The keypad gives continuous beeps for 1 minute after power-up.
2) The power-up delay can be stopped instantly with
and setting the keypad to programming mode with DAP code is not required.
POWER-UP DELAY STOP
 
3) The keypad will set itself to Normal Operation Mode automatically after the 1 minute power-up

delay expired or it is stopped with
SET KEYPAD IN PROGRAMMING MODE WITH MASTER CODE
It is always necessary to set the keypad in programming mode for feature programming
The keypad is in normal operation after power-up delay. Set it in programming mode with Master

Code and validate it with or
MASTER CODE
NOTE:
a) For those keypads with door bell button, the
b) For the owner's convenience in programming at the first time, a Master Code 0 0 0 0 has been
put into the keypad before exit-factory. It is NOT a default code. For security reason, owner
should program a personal Master Code to replace it after the keypad is owned.
c) The Mains LED (amber) is ON after the keypad confirms it in programming mode with 2 beeps.
d) DO NOT turn off power while the keypad is in programming mode. Otherwise, it may cause error
to the data in memory.

if the delay beep is found annoying
VALIDATION
.

.
VALIDATION

button is equivalent to the
15
button.